Perun MOSFET ETU++ For G&G G2 ETU AEG

This electronic trigger unit replaces the stock electronics board in your Airsoft replica by disconnecting the stock board and plugging in the ETU++. The unit provides a wide variety of advanced features to enhance your Airsoft gameplay and experience. This MOSFET offers the following programmable modes:

• Independently programmed firing modes - Offers programmable firing modes to the settings of your choosing, such as setting safe, semi, burst or auto on your choice of fire selector positions.
• Active brake - Stops the motor after each shot, which prevents spring compression or avoid overspin/double shot in replicas with a high rate of fire, adding another level or reliability.
• Precocking - Set a near-instantaneous trigger response. With precocking enabled, the piston will remain in its rear position after each shot with spring automatically compressing. This ensures that the next shot will be fired immediately after you pull the trigger. To release the spring after precocking, simply pull the trigger and hold it for 2 seconds, after which a second shot will be fired, this time with no precocking and fully braked.
• Binary trigger - Allows for easy double shots when the fire select is set to semi-auto. After this mode is enabled, if semi-automatic fire is set, the shots will be fired not only when the trigger is pulled, but also when it is released.
• Rate of fire reduction - Reduce the rate of fire in automatic or burst fire to save ammo or make your replica shoot in a more realistic fashion.
• DMR mode - Set intervals between semi-automatic shots, which will allow you comply with DMR rules on some skirmish sites.
• Low battery voltage alarm - When used with Li-Po and Li-Ion batteries, the MOSFET will detect when the battery voltage falls to a critically low level, you will be notified by short sound signals that are repeated every minute. Easily switched on and off, this setting will prevent damage to your battery and improve its lifespan.
• Diagnostic system - Monitors the replica and the MOSFET itself. In case of any issues, this setting immediately lets you know what the issue might be, making troubleshooting much easier.
• Electronic fuse - Save your replica and battery from a major malfunction. This setting will automatically disconnect the battery when a short circuit or blocked motor is detected.

Programming of all the settings is done solely by using quick and easily memorable sequences of fire selector, detailed in the manual. The trigger pulls are accompanied by sound signals and multicolour LED diodes. This allows for setting adjustment on the fly in a matter of seconds, even under enemy fire. All settings are set independently for each selector position, so you can program the MOSFET exactly the way you want.

Features

• Advanced features and settings
• Deans battery connector
• Fully programmable - play the way you want!
• Easily switch settings on the fly
• Easy system diagnostics
• Programmable fire controls including 2-5rnd burst
• Set fire modes on the position of your choice
• Specifically designed to replace the G&G G2 ETU - Not compatible with other platforms

Package Includes

• Perun MOSFET ETU++ For G&G G2 ETU AEG