GATE NanoHARD 3rd Gen Multifunction AEG Controller

The chip provides active breaking, which stops the motor from over spinning, which can be turned on and off to the users requirements. The chip-set also features a Smart Fuse, which is their latest and most reliable fuse they have made to date, featuring a true current sensor. With a combination of current, voltage and temperature measurements the fuse protects your rifle from a variety of problems, such as: Overheating, Overloading, Short Circuiting, and protects the Motor and Battery against damage from Jamming. The in-built MOSFET is designed to achieve a higher rate of fire and trigger response, as well as protects the mechanical trigger contacts by directly bypassing the contacts and going straight to the motor. The chip set also provides protection against the over-discharge of LiPo battery, and once activated with prevent them from dropping below their nominal usage levels by constantly monitoring the voltage then stopping the weapon from firing when the power is too low. The system also provides protection from contact bounce, providing a higher ROF, a better trigger response and making the unit less prone to heating. This LiPo can be used at a minimum of 3v, and up to 17v, making it ready for 14.8v LiPo Batteries. The body of the unit is coated to the Mil-Spec variation MIL-V-173c, making it resistant to atmospheric conditions. The package comes with everything you need to connect up the unit, with spare wires for different trigger setups, as well as jumpers and configuration button.

• Battery Support: 7.4v LiPo, 11.1v LiPo, 14.8v LiPo (See Special Instructions)
• Operating Ranges: 3v - 17v
• User Guide: Click Here

Features

• 12 Months Warranty
• Multifunctional Programmable AEG Controller
• 3rd Generation MOSFETS
• On / Off Active Break Functionality
• Built-in Self Test
• Trigger Protecting MOSFET
• Battery Over-Discharge Protection
• Debouncing to prevent contact bounce
• Smaller and more compact than over units on the market
• 14.8v LiPo Ready
• Mil-Spec MIL-V-173C Coated
• Increases the ROF of your AEG
• Provides a better Trigger Response
• Heat-up Resistant Unit
• Increase the service life of batteries
• Protects Jammed Rifles from further damage
• Protected from Overheating, Overloading and Short-Circuiting
• Kit comes with all required parts

Package Includes

• NanoHARD 3rd Gen Multifunction AEG Controller
• Deans Connector Male x1
• Deans Connector Female x1
• Single Signal Wire for Trigger Contacts x1
• Double Signal Wire for Trigger Contacts x1
• Jumper Connector x2
• System Programming Button x1

Special Instructions

Should you need any help installing the MOSFET please feel free to call our workshop on: 01484 644709.

Support for more battery types (Such as Ni-Mh) and can be activated by disabling the discharge protection on the chip.

Please note that the warranty covers the unit from defects, not improper installation. Please read all user guides before installing.

Please remember when installing the device to ensure your AEG is clear before use,

Ensure that when wiring up the device the Positive and Negative battery terminals are the correct way around as this will cause immediate damage to the unit.

For warranty related issues please visit: http://gatee.eu/technical-support/warranty

Version Comparisons