LiPo Batteries

If you're looking for the very smallest of LiPo batteries, you've found it. Measuring 4x1.3x2cm, this battery can be used to power the FCU in the V12 engine, in addition to other HPA systems with a mini-JST type connector.

The battery has a voltage of 7.4v, a capacity of 250mAh and a discharge rate of 20C and features a cable length of roughly 10.5cm

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

A stick battery designed for most M4 stock tubes, solid stock sand some hand guards. An ideal starter LiPo which you should get half a days use out of at least from a slow charge.

A compact 7.4v two cell stick battery that is ideal for squeezing into small spaces like stock tubes, especially the battery spaces on Honey Badgers and compact weapons with an extending skeleton stock.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. 

If you need slim 7.4V crane stock LiPo for your crane stock or handguard battery compartment, the VP Racing 7.4V 1000mAh 20c LiPo Crane Stock Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and is comprised of 2 cells, each of which measures 11 x 1.5 x 0.5 cm. The wire length between the cells and connector is approximately 10cm, giving you a bit of flexibility to ensure the battery is installed properly. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A high quality and ultra compact 7.4v Lithium Polymer Battery with 850mAh of capacity, wth a 30C discharge rating.

Those of you with limited battery space, this block battery is the one! The battery will fit near enough all AEG rifles and will be especially useful in rifles with PDW stocks. It has a voltage of 7.4v, a capacity of 2800mAh and a discharge 30C. The battery is connected to your AEG via the Deans connector, not to be confused with Mini-Tamiya connector, however, adaptors are available.

The battery measures 7.5x1.5x2.5cm with a cable length of roughly 4cm.

VAPEX are well known for their high quality and high performance batteries with this one being a block form factor. The battery has a voltage of 7.4v, has a capacity of 1300mAh and a discharge rate of 30C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery's dimensions are 10x1.2x3cm with a cable length of roughly 10cm. This battery should fit AEGs with larger battery compartments such as full stock AKs and M16s, within the handguard of AR36s and front wired MP5s.

Those of you looking for a battery with a large capacity in a medium-sized block form factor, you've come to the right place! The battery is perfect for larger areas such as full-stocked SMG-5, G3, M16 and AK platforms, AR36 handguards and full-stock rifles. The battery has a voltage of 7.4v, a capacity of 2300mAh and a continuous discharge rate of 20C with a maximum discharge rate of 40C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 10x1.5x3.4cm with a cable length of roughly 10cm.

If you need spare batteries for your AEP with a bit more oomph than the standard NiMh, this will do it! The IPower 7.4v 680mAh 20c LiPo Micro Battery is designed for CYMA CM.1xx series AEPs, fitted with a standard AEP connector and sized to fit AEP battery compartments. This battery is NOT compatible with AEP SMGs like the VZ61, MAC-10 or SMG-7 or the MOSFET-equipped CM.1xxS series. 

This battery can be charged via its balance port using a LiPo balance charger, and as always, we recommend never leaving a LiPo on charge unattended and always using a LiPo charging bag.

A 7.4v Lithium Polymer Battery designed for use in battery compartments with limited space for a thin, but long battery.

A 7.4v 1450mAh LiPo stick battery suitable not only for Airsoft but for RC vehicles and toys too.

A LiPo battery with a universal electric pistol connection that will allow it to be used in pretty much every Airsoft Electric Pistol we can think of.

Those of you looking for a battery with a truly large capacity, you've come to the right place! The battery is perfect for larger battery compartments such as SMG-5, G3, M16 and AK platforms with fixed stock battery compartments. The battery has a voltage of 7.4v, a capacity of 2800mAh and a continuous discharge rate of 25C with a maximum discharge rate of 50C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 13x1.1x4.2cm with a cable length of roughly 10cm.

If you need a battery for your handguard or full stock battery compartment this should do the trick! The 7.4v 1600mAh 25C LiPo Battery from Giant Power is nice and compact, measuring 9.5x1.2x3cm approximately, making it great for handguard battery compartments in SMG-5 and AR36 AEGs and also an easy fit in M16 and AK full stocks.

The battery is pre-wired with a mini-Tamiya battery connector and is in block configuration, meaning both cells are bound together. The wire length between the battery itself and the connector is approximately 10cm and the continuous discharge rate is 25C, making this battery ideal both for Airsoft and any electronics hobby which requires a compact power source.

If you run a front-wired AEG with limited battery space, storing your battery in a PEQ-15 battery box could be the solution! This 7.4v 1000mAh 30C LiPo battery from Electro River is designed to fit into cramped spaces and is the perfect size for use in a PEQ-15 battery box. The battery measures  6.4 x 1.2 x 3.3cm approximately and the wire length between the cell group and connector is approximately 9.5cm.

The compact size of this battery makes it great for both Airsoft and any other electronics projects you have on the go, providing plenty of juice in a smaller form factor. The continuous discharge rate of this battery is 30C and its peak is 60C, giving you a nice snappy response without overdoing things!

Giant Power are well known for their high quality and high performance batteries with this one being a block form factor. The battery has a voltage of 7.4v, has a capacity of 1300mAh and a discharge rate of 35C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery's dimensions are 7x1.5x3.4cm with a cable length of roughly 7.5cm. This battery should fit AEGs with larger battery compartments such as full stock AKs and M16s, within the handguard of AR36s and front wired MP5s.

If you need a battery for your M4/AR-15 AEG Crane stock and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery in Crane configuration with a Deans connector; an ideal setup for a Deans equipped rear wired M4/AR-15 AEG with a Crane stock battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 0.7cm x 1.5cm per cell group (2 cell groups on each battery) with approximately 9cm of wiring between the battery and connector. 

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery with a Mini-Tamiya connector; an ideal setup for a Deans equipped rear wired M4/AR-15 AEG with a buffer tube battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 1.3cm x 1.5cm with approximately 9cm of wiring between the battery and connector

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery in Crane configurations with a Mini-Tamiya connector; an ideal setup for a Mini-Tamiya equipped rear wired M4/AR-15 AEG with a Crane stock battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 0.7cm x 1.5cm per cell group (2x cell groups on each battery) with approximately 9cm of wiring between the battery and connector. 

This LiPo battery from Gens Ace is designed to fit into compact and slim battery compartments, such as the M4/AR15 buffer tube and the AK47/74 top cover. The battery connects to your AEG via a Deans connector (AKA T-Plug) and provides 1400mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8.5cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

If you need a compact 7.4V LiPo for your buffer tube, PDW stock or other cramped battery compartment, the VP Racing 7.4V 800mAh 20c LiPo Stick Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and measures 10.2 x 1.1 x 1.9 cm with 5cm of wire length, making it suitable for most Airsoft AEGs, even those with small battery compartments. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A LiPo saddle battery designed to fit in handguards in replacement of the traditional 1600mAh NiMH blocks/saddles (G36 handguards etc).

If you like to be at the cutting edge of battery technology when it comes to Airsoft, you're going to want to check this out! The Gens Ace 7.4V 25C 1000mAh Airsoft LiPo Battery - Mini-Tamiya is a slim LiPo battery intended for Airsoft buffer tube battery compartments, AK top covers and other cramped spaces requiring a single cell group. The discharge rate is 25C, giving you a snappy response without risking overspin in most setups, and the capacity is 1000mAh, meaning you might need two to get through a full game day. 

Where this battery differs from the norm is its Smart Balance Connector which interfaces with the Gens Ace IMARS Mini Charger, communicating the battery type and current charge levels and immediately commencing optimal charging as soon as this "Smart Battery" is connected. Compared to legacy smart chargers, this saves loads of time but unfortunately means that this battery cannot be charged using a standard LiPo balance charger. 

If you need a slim stick battery for your ASG Scorpion, M4/AR-15 AEG buffer tube or top-wired AK AEG this will do the trick! The Gen's Ace 7.4v 1200mAh 25C LiPo Stick Battery measures approximately 13x1x2cm which makes it perfect for rear wired M4 platforms with the standard buffer tube battery compartment, top wired AKs which house their battery beneath the top cover and SMG-5K platforms. The battery is pre-wired to a Deans connector and the length of wire between the cell group and the connector is approximately 6cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C, making it great for almost any Airsoft AEG and a perfect fit for the ASG Scorpion EVO 3A1, though make sure you measure before ordering!

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

If you need a battery for your AR36 AEG or polymer handguard equipped M4/AR-15 AEG this one will do the trick! The 7.4v 1800mAh 20C LiPo Flat Nunchuck Battery from Electro River is a flat nunchuck style battery, also known as a "butterfly" configuration. Unlike other nunchuck batteries, this won't inside a crane stock and is more suitable for large polymer handguards such as those found on AR36 and M4A1 AEGs and will also fit nicely in most fixed rifle stocks.

The battery itself is a 2-cell 7.4V LiPo with a wire length of approximately 9cm between the cell groups and the connector, and each of the two cell groups measures 10 x 0.6 x 3.5cm approximately. The pre-wired connector is the common mini-Tamiya type and the continuous discharge rate is 20C, with a maximum discharge rate of 40C.

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a mini-Tamiya connector and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a Deans connector (aka a T-Plug) and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.