VAPEX Airsoft Batteries

If you need slim 7.4V crane stock LiPo for your crane stock or handguard battery compartment, the VP Racing 7.4V 1000mAh 20c LiPo Crane Stock Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and is comprised of 2 cells, each of which measures 11 x 1.5 x 0.5 cm. The wire length between the cells and connector is approximately 10cm, giving you a bit of flexibility to ensure the battery is installed properly. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A large stick type battery, designed to output a high power for fast trigger response and rate of fire for up to three quarters of a day on a slow charge.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. Fitted with a deans connector for low resistance.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards  and comes fitted with Deans connectors instead of the standard Tamiya for upgraded Airsoft Guns.

If you need a battery for your M4/AR-15 buffer tube or your top-wired AK AEG this should be perfect! The VAPEX 7.4v 1300mAh 20C LiPo Stick Battery measures 14 x 1.2 x 1.8cm approximately with a wire length of 9cm, making it a good fit in rear wired M4s with a buffer tube battery compartment, SMG-5K AEGs or AK AEGs in the top-wired configuration.

The pre-installed battery connector is the common mini-Tamiya type and the battery has a discharge rate of 20C, making it ideal for Airsoft applications but also useful for those needing a compact power source for electronics or R/C projects.

A super thin triple crane stock 11.1v 1300mAh 25C LiPo, which features a Deans Connector instead of the standard Mini Tamiya. 

A high voltage Airsoft Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

Those of you with limited battery space, this block battery is the one! The battery will fit near enough all AEG rifles and will be especially useful in rifles with PDW stocks. It has a voltage of 7.4v, a capacity of 2800mAh and a discharge 30C. The battery is connected to your AEG via the Deans connector, not to be confused with Mini-Tamiya connector, however, adaptors are available.

The battery measures 7.5x1.5x2.5cm with a cable length of roughly 4cm.

A triple crane stock 11.1v 1450mAh 25C LiPo, which features a Deans connector instead of the standard small Tamiya.

VAPEX are well known for their high quality and high performance batteries with this one being a block form factor. The battery has a voltage of 7.4v, has a capacity of 1300mAh and a discharge rate of 30C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery's dimensions are 10x1.2x3cm with a cable length of roughly 10cm. This battery should fit AEGs with larger battery compartments such as full stock AKs and M16s, within the handguard of AR36s and front wired MP5s.

If you need a compact 11.1V LiPo for your buffer tube, PDW stock or other cramped battery compartment, the VP Racing 11.1V 800mAh 20c LiPo Stick Battery should do the trick. This 11.1V 3S LiPo stick battery is fitted with a Deans battery connector and measures 10.4 x 1.7 x 1.9 cm with 4cm of wire length, making it suitable for upgraded Airsoft AEGs, even those with small battery compartments. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A high output VP Racing 11.1v 1450mAh LiPo battery, designed to deliver some serious rate of fire and trigger response with the right setup.

If you're looking for an 11.1V LiPo which fits neatly into an AR buffer tube, this is the one! The VP Racing 11.1V 1300mAh 25c LiPo Stick Battery - Deans measures approximately 10.4 x 1.9 x 1.9 cm with 4cm of wire length, making it great for buffer tubes and other cramped but relatively long battery compartments. As always, make sure you measure your battery compartment before ordering to avoid disappointment!

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. 

If you are looking for a decently sized crane stock battery which should last all day, the VAPEX 7.4v 2200mAh 20C LiPo Crane Battery should do the trick! This battery is a 7.4V 2S LiPo in crane/nunchuck configuration, meaning the cells are separated into two individual units which makes the battery far easier to fit into unconventionally shaped battery compartments. The pre-wired connector is the common mini-Tamiya connector and the continuous discharge rate is 20C.

Each of the individual cell units measures 11x2.2x1.2cm approximately with a wire length of 9cm between each cell and the connector, meaning this should fit nicely in most crane stocks and many handguards and full-stock battery compartments, though as always, we advise measuring carefully before ordering!

A four pack of AAA batteries rated at 1.5v - ideal for a wide range of Airsoft accessories and remotes as well as other hobbies like RC Cars, Boats and Planes.

An individual 3V Lithium Button Battery, which are commonly used in Airsoft Sights, Scopes and other Accessories. 

If you need a compact Airsoft battery which fits almost anywhere the 7.4v 1100mAh 20C LiPo Crane Battery from VAPEX is ideal. This battery is pre-wired with a mini-Tamiya battery connector and each cell unit measures 11 x 0.7 x 2.2 cm with approximately 9 cm of wiring between each cell and the connector, making it great for tight spaces and use with multiple different platforms.

The compact size of this crane/nunchuck battery makes it ideal not only for Airsoft but also for electronics hobby applications and R/C when a lightweight and compact power source is a priority. Whether it needs to fit into a buffer tube, crane stock, handguard or practically anywhere else this super slim battery is perfect, especially if you want a single battery which fits in multiple guns!

A compact yet high output LiPo battery designed for most M4 stock tubes, solid stocks and some hand guards.

A super thin triple crane stock 11.1v 1300mAh 25C LiPo that features a standard Tamiya connector and is made up of three individual thin cells, making it great for squeezing into awkward spaces.

A high quality 800mAh 11.1V LiPo battery suitable for Airsoft and RC use. This is a single stick type battery will fit into most Airsoft AEG hand guards or stocks and stock tubes.

If you need a compact 7.4V LiPo for your buffer tube, PDW stock or other cramped battery compartment, the VP Racing 7.4V 800mAh 20c LiPo Stick Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and measures 10.2 x 1.1 x 1.9 cm with 5cm of wire length, making it suitable for most Airsoft AEGs, even those with small battery compartments. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A must have battery for any avid RC user or Airsofter that requires enough power to last all day of full auto or a full weekend Milsim. 

A compact battery which is smaller than a CR123A and is used a wide range of Airsoft accessories and cameras/torches.