All Airsoft Batteries

If you need a battery for your M4/AR-15 buffer tube or your top-wired AK AEG this should be perfect! The VAPEX 7.4v 1300mAh 20C LiPo Stick Battery measures 14 x 1.2 x 1.8cm approximately with a wire length of 9cm, making it a good fit in rear wired M4s with a buffer tube battery compartment, SMG-5K AEGs or AK AEGs in the top-wired configuration.

The pre-installed battery connector is the common mini-Tamiya type and the battery has a discharge rate of 20C, making it ideal for Airsoft applications but also useful for those needing a compact power source for electronics or R/C projects.

An ultra thin, long LiPo crane stock battery. The battery is designed to fit into as little space as possible, taking up very little room allowing it to be fit into stocks and small battery compartments.

This 7.4v 1100mAh LiPo Stick Battery from NUPROL delivers high rate of fire, reliability and durability at a low cost. It can be easily stored in the front end of most popular AEGs such as an M4 or M16.

A large stick type battery, designed to output a high power for fast trigger response and rate of fire for up to three quarters of a day on a slow charge.

If you want the biggest stick battery you can squeeze into your M4/AR-15 buffer tube, this is probably it! The Specna Arms 7.4v 2000mAh 15/30c LiPo Stick Battery is pre-wired to a mini-Tamiya battery connector and designed for slim and long battery compartments. The battery is a 7.4V LiPo with a capacity of 2000mAh, continuous discharge rate of 15C and maximum discharge rate of 30C.

The battery measures 12.3 x 1.6 x 1.8cm approximately and should fit into most M4/AR-15 buffer tubes, though some with less space inside may require that you leave the stock in an extended position. The wire between the cell group and connector is approximately 10cm, giving you plenty of flexibility to fit the battery where you need it. As always, measure up before you buy!

A 7.4v 1500mAh LiPo battery that provides a 20c discharge rate and is highly compact, making it ideal for external PEQ battery boxes and tight spaces.

A high voltage Airsoft Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

An ultra thin and lightweight crane stock battery, perfect for squeezing into the ever more popular Airsoft crane stock.

A large stick type LiPo battery, ideally suited to fitting inside an M4 or M16 type AEG stock tube.

If you need a slim stick battery for your AK or SMG-5 AEG this will do the trick! The Giant Power 7.4v 1300mAh 25C LiPo Stick Battery measures approximately 18.5x1x2cm, which makes it perfect for longer battery compartments such as AK dust covers and SMG-5 platforms. The battery is pre-wired to a Mini-Tamiya connector and the length of wire between the cell group and the connector is approximately 6cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C, making it great for almost any Airsoft AEGs, RC cars and more!

An ultra thin and lightweight battery, designed to squeeze into AK compartments. The battery provides 1100mAh of power with a discharge rate of 40C.

Suitable not only for Airsoft but for RC vehicles and toys too, this  7.4v 2200mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries wouldn't normally.

A high output VP Racing 11.1v 1450mAh LiPo battery, designed to deliver some serious rate of fire and trigger response with the right setup.

An 11.1v 1200mAh 20c LiPo Battery in a Slim Stick configuration, complete with a Deans Connector. It has total dimension of: 1.35cm x 1.62cm x 18.5cm and is perfect for up-rated guns and rifles with a high power draw such as DMRs and high rate of fire setups, and other replicas that require a Stick Battery down the Receiver, such as AK/UMP models.

A high quality 1300mAh 11.1V LiPo battery suitable for Airsoft and RC use. A single stick type battery that will fit into most Airsoft AEG hand guards or stocks and stock tubes.

A high quality 11.1V LiPo battery with a 1200mAh capacity, suitable for both Airsoft and RC use.

If you're looking for the very smallest of LiPo batteries, you've found it. Measuring 4x1.3x2cm, this battery can be used to power the FCU in the V12 engine, in addition to other HPA systems with a mini-JST type connector.

The battery has a voltage of 7.4v, a capacity of 250mAh and a discharge rate of 20C and features a cable length of roughly 10.5cm

Suitable not only for Airsoft but for RC vehicles and toys too, this  7.4v 2200mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries would normally not.

A stick battery designed for most M4 stock tubes, solid stock sand some hand guards. An ideal starter LiPo which you should get half a days use out of at least from a slow charge.

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

An 11.1v 1300mAh 20c LiPo Battery in a PEQ Box configuration, which makes it perfect for hiding inside a PEQ Box. It has a 9cm cable with a Deans Connector on the end, and total dimensions of: 1.65cm x 4.15cm x 6.6cm.

A compact 7.4v two cell stick battery that is ideal for squeezing into small spaces like stock tubes, especially the battery spaces on Honey Badgers and compact weapons with an extending skeleton stock.

A super thin, triple cell crane stock styled 11.1v LiPo battery, featuring a small Tamiya connector for easy use.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. 

If you need slim 7.4V crane stock LiPo for your crane stock or handguard battery compartment, the VP Racing 7.4V 1000mAh 20c LiPo Crane Stock Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and is comprised of 2 cells, each of which measures 11 x 1.5 x 0.5 cm. The wire length between the cells and connector is approximately 10cm, giving you a bit of flexibility to ensure the battery is installed properly. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A high quality and ultra compact 7.4v Lithium Polymer Battery with 850mAh of capacity, wth a 30C discharge rating.

If you're looking for an 11.1V LiPo which fits neatly into an AR buffer tube, this is the one! The VP Racing 11.1V 1300mAh 25c LiPo Stick Battery - Deans measures approximately 10.4 x 1.9 x 1.9 cm with 4cm of wire length, making it great for buffer tubes and other cramped but relatively long battery compartments. As always, make sure you measure your battery compartment before ordering to avoid disappointment!

VAPEX are well known for their high quality and high performance batteries with this one being a block form factor. The battery has a voltage of 7.4v, has a capacity of 1300mAh and a discharge rate of 30C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery's dimensions are 10x1.2x3cm with a cable length of roughly 10cm. This battery should fit AEGs with larger battery compartments such as full stock AKs and M16s, within the handguard of AR36s and front wired MP5s.

Those of you with limited battery space, this block battery is the one! The battery will fit near enough all AEG rifles and will be especially useful in rifles with PDW stocks. It has a voltage of 7.4v, a capacity of 2800mAh and a discharge 30C. The battery is connected to your AEG via the Deans connector, not to be confused with Mini-Tamiya connector, however, adaptors are available.

The battery measures 7.5x1.5x2.5cm with a cable length of roughly 4cm.

A super thin triple crane stock 11.1v 1300mAh 25C LiPo, which features a Deans Connector instead of the standard Mini Tamiya.